A hydraulic fracturing, or fracking, site as seen from the air near Fort St. John, B.C. JeremyWilliams.ca

A hydraulic fracturing, or fracking, site as seen from the air near Fort St. John, B.C. JeremyWilliams.ca

B.C. regulator says fracking caused earthquakes near Fort St. John

Hydraulic fracturing involves injecting water, sand and chemicals into a well under pressure to break up tight underground rock and free trapped oil and gas.

  • Dec. 21, 2018 12:00 a.m.

The B.C. Oil and Gas Commission has blamed fracking for three earthquakes in northeastern B.C. last month.

The provincial regulator says the events 20 kilometres south of Fort St. John on Nov. 29 occurred because of fluid injections during hydraulic fracturing at a Canadian Natural Resources Ltd. wellsite.

The events, which were felt but caused no surface damage, measured 3.4, 4.0 and 4.5 magnitude.

Fracking operations within the lower Montney formation were suspended after the earthquakes and are to remain suspended at the multi-well pad involved pending the results of a detailed technical review.

The commission says seven wells into the upper Montney formation had previously been drilled and completed by the Calgary-based company at the well pad with no seismic events larger than magnitude 2.5 detected.

The immediate shut down of operations is required when an induced seismic event in that region reaches or exceeds a 3.0 magnitude.

Hydraulic fracturing involves injecting water, sand and chemicals into a well under pressure to break up tight underground rock and free trapped oil and gas.

Read more: 4.5 magnitude earthquake strikes near Fort St. John

Read more: Northeast B.C. community cut off by slide has heat, power, but no answers

Companies in this article: (TSX:CNQ)

The Canadian Press

Like us on Facebook and follow us on Twitter.

Abbotsford News